Land Clearing in Crawfordville, Florida

Forestry mulching, underbrushing and lot clearing across Crawfordville and Wakulla County. One machine cuts, grinds and spreads in a single pass, so nothing is piled, burned or hauled off your place.

  • Priced from photographs, usually same day
  • Both of our jobs here were single machine days
  • From $3,000 a machine day
$3,000Minimum, per machine day
2Finished jobs in Crawfordville
2Machine days, one each
3Machines, at 8, 24 and 30 inches

What we clear in Crawfordville

Eight things we are actually asked for on Wakulla County ground. If your job is not on this list, say so and we will tell you straight whether it is ours.

Forestry mulching

One machine cuts standing growth and grinds it back into the ground as chip in the same pass. No pile, no burn, no trucks.

Titi and gallberry removal

The two that fill wet flatwoods here and the reason most parcels stop being walkable. Dense, low forking and slower going than they look.

Homesite and lot clearing

A lot back to ground you can walk and build on, on ground where piling and burning is rarely practical anyway.

Selective clearing

You mark the pines and the oaks that stay and we cut round them.

Excavator clearing and grubbing

Where the roots have to come out rather than the top growth being ground off. Our 30 inch excavator mulcher.

Home site preparation

Building envelope, drive and pad taken down to workable ground before your builder arrives.

Trail and access cutting

A drive line in from the road, or a lane cut through a block on ground with no firm track on it yet.

Fence and boundary lines

A line you can run wire along or walk, cut without disturbing what is either side of it.

Who calls us in Wakulla County

People building outside town

Most of the county is forest, so homesites here are usually cut out of standing timber rather than dropped on cleared ground.

Owners of wet flatwoods

Titi and gallberry ground with the water table close to the surface. It reads as impassable and is normally a day or two of work.

Owners with a lot beside the forest

Parcels backing onto national forest where the understory has never been touched and comes right up to the line.

People about to build

Clearing the envelope, the drive and the pad before the builder mobilises, so the site is ready rather than a delay.

Owners who cannot burn

Piling and burning is a poor fit on this ground and often not an option. Mulching leaves the material where it falls as chip.

Sellers and agents

A parcel nobody can walk is a parcel nobody buys. A day with a mulcher changes what a buyer is looking at.

How the work runs

Four steps, and the first two happen before anything leaves our yard.

Send photographs

Pictures with something in frame for scale, the lot size, and a note on what you want left standing. If there is standing water anywhere, photograph that too.

We give you a real number

Usually the same day. It is a day count against a published rate, not a guess dressed up as a quote.

One machine, one pass

The mulching head cuts, grinds and spreads as it goes. No separate clear, pile and haul stage, which is where most of the cost and all of the mess normally sits.

You get a mulch layer

Not bare ground and not a field of cut stems. On soft wet ground that chip layer is what gives you a surface to walk and work on afterwards.

What it costs

We sell machine days, not acres, and we publish the rates. Both jobs here were single days, and the interesting part is that the smaller of the two ran on the smaller machine while the acre needed the dearest one we own.

Skid steer mulcherFrom $3,000

Stems to 8 inches. Transport included. The machine recorded on our three quarter acre job here

Excavator mulcherFrom $3,500

Stems to 30 inches, and grubbing. Plus transport

Dedicated mulcherFrom $4,000

Stems to 24 inches. Plus transport. The dearest machine we run

What moves the day count

Standing water and how long it staysTiti densityTrees you want keptWhether the approach firms upBuild timelineAccess off the county road

The rate follows the machine rather than the size of the stem, which catches people out: the dedicated mulcher costs more than the excavator even though the excavator takes bigger timber and pulls roots. Transport is the cost of getting the bigger two machines to you and is separate from hauling material away, which is quoted per job.

What we have actually done in Crawfordville

Two finished jobs, a machine day each, Sep 2024 to Jan 2026. Every Wakulla County job on our books is in Crawfordville.

Sep 2024One acre, 1 machine day, with the dedicated mulcher
Jan 2026Three quarters of an acre, 1 machine day, with the skid steer mulcher
The county totalTwo jobs, 2 machine days, both here in Crawfordville

Two similar sized parcels, two single days, two different machines. The acre needed the dedicated mulcher, which is the dearest machine we run, and the three quarter acre parcel ran on the cheapest with transport included. A quarter of an acre of difference did not decide that. What was standing on it did, and that is the whole reason we ask for photographs before quoting.

The ground on a Wakulla County parcel

What grows hereSlash pine flatwoods over most of it, with titi, gallberry and fetterbush filling in underneath, live oak and magnolia on the few higher spots, and cypress in the drains and along the creeks
What that means for a machineTiti is the slow part. It forks low and grows dense enough that a machine works in short bites, and a parcel that is mostly titi will read heavier in the day count than the acreage suggests
WaterThis is the constraint here rather than a footnote. The water table sits close to the surface across most of the county and much of the low ground holds water for weeks after heavy rain. A wet fortnight moves a booking
AccessCounty roads and sand tracks, with national forest on three sides of the county. The approach is worth a photograph, because ground that carries a pickup does not always carry a low loader
0.25 acres

The difference in size between our two Crawfordville jobs. It did not decide which machine went. What was standing on the ground did, and that is what a photograph tells us and an acreage does not.

What customers say

★★★★★

FloridaLandClearing.com was beyond helpful in getting our property cleared. They were spot on with their quote, their crews arrived on time, and the machines they used were impressive to watch.

Jenny Anderson
★★★★★

We had a difficult project a few other companies attempted and left. Florida Land Clearing was able to get the job done and a day earlier than quoted.

Joseph Kelly
★★★★★

These guys are pros. Watching these machines just devour acres of underbrush in a day was one of the coolest things I have seen. I cannot believe how this transformed my property.

Adam Wilson

Before you book: trees on a Wakulla County parcel

Wakulla County rules apply to the unincorporated county, which covers most of it including Crawfordville, and ground near a creek or wetland may involve the water management district as well.

What is protected depends on the species and the size of the trunk, and whether the parcel is a single family homesite, working timber or land being developed. In a county that is mostly forest, the silvicultural and wetland questions come up more often than the tree by tree ones do.

Tell us what you want gone and what you want kept when you send photographs. If any part of the parcel holds water or runs towards a creek, mention it, because that is the case most worth settling before anyone books a machine.

We are a clearing contractor, not the permit office, and we do not file applications. Confirm your own parcel and your own trees with Wakulla County or the water management district before you commit.

Crawfordville questions

How much does it cost to clear a lot in Crawfordville?

From $3,000 a machine day. Both of our jobs here were single days. Send photographs and the lot size and we will confirm a day count and which machine we would bring.

Why did a smaller lot cost less than a slightly larger one?

Because of the machine, not the size. Our acre job needed the dedicated mulcher at the top of our rate card and the three quarter acre parcel ran on the skid steer with transport included. What is standing decides the machine and the machine decides the rate.

Can you work on wet ground?

Usually, and tracked machines cope with a lot. But there is a point where the right answer is to wait rather than tear the ground up, and we will tell you when we think you are at it. A wet fortnight here moves bookings.

How long does it take?

A day, for both of the parcels we have done here. Dense titi across a whole parcel is what would push it further, and that shows up clearly in photographs.

What happens to everything you cut?

It stays on the ground as mulch, spread as the machine goes. Nothing piled, nothing burned, which on this ground is an advantage rather than just a preference.

Do I need a permit?

It depends on the species and size of what is standing and how close the work is to a creek or wetland. Crawfordville sits in the unincorporated county, so the county is who to ask. Confirm with them rather than taking a contractor word for it, ours included.

Are you licensed and insured?

Insured, and we send the certificate before the machine moves. Florida does not issue a contractor licence for forestry mulching, so nobody holds one. Insurance is the document worth asking every contractor to produce.

Get a price on your Crawfordville lot

Send a few photographs, the lot size and a note on what you want left standing. Photograph any standing water as well, because on this ground that is the thing most likely to move your date.

Call or text 813-733-6607